[제품설명]
(470-698MHz) 동시 41개 사용가능
ULX® Standard UHF wireless (ULX-S)는 현역에서 활동하고 있는 아티스트나 전문 음향 설치 업자들에게 파격적인 성능과 가격을 제시합니다.
• 그룹/주파수 자동 스캔 설정
• 1440개의 선택 가능 주파수
• 5단계 오디오 미터
• RF 표시 LED
• 3단계 건전지 잔량 표시
• 다기능 그룹/채널 표시 LCD창
• 마이크/라인 스위치
• 탈착 가능한 1/4파장 안테나
• XLR 및 1/4”출력
• 견고한 플라스틱 섀시
• 1/2 랙 디자인
Compatible Systems Per Band_?xml_:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />
|
Up to 20*
|
Compatible Systems Using Multiple Bands
|
62*
|
Selectable Frequencies
|
1440
|
Auto-Setup
|
Scan / Channel Scan
|
Detachable Antenna
|
Yes |
RF Carrier Frequency Range
470.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is used). Refer to the frequency supplement supplied with the system.
Effective Range
100 m (300 ft.) under optimal conditions
NOTE: Actual working range depends on RF signal absorption, reflection, and interference
Audio Frequency Response
25 to 15,000 Hz, +/- 2 dB
NOTE: Overall system frequency response depends on the microphone element.
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
Transmitter Gain Adjustment Range
ULX1: 25 dB
ULX2: 25 dB
Receiver Audio Output Level (+/- 38 kHz deviation, 1 kHz tone)
XLR connector (into 600 ohm load): +3.9 dBV (line), -17 dBV (mic)
1/4 inch connector (into 3000 ohm load): -2 dBV
Impedance
ULX1 (input): 1 Megohm ULXS4, ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
Modulation
+/- 38 kHz deviation compressor-expander system with pre- and de-emphasis.
RF Power Output
ULX1, ULX2: 30 mW maximum
Dynamic Range
>100 dB, A-weighted
RF Sensitivity
1.26 microVolt for 12 dB SINAD (typical)
Image Rejection
80 dB typical
Spurious Rejection
75 dB typical
Ultimate Quieting (reference +/- 38 kHz deviation)
>105 dB, A-weighted
System Distortion (reference +/- 38 kHz deviation, 1 kHz modulation)
0.3% total harmonic distortion, typical
Power Requirements
ULX1, ULX2: 9V alkaline battery; 8.4 V Nicad optional
ULXS4, ULXP4: 14 - 18 Vdc (negative ground), 550 mA
Battery Life
8 to 9 hours (with 9V alkaline battery)
Operating Temperature Range
-20 degrees to 49 degrees C (-4 degrees to 120 degrees F)
NOTE: Battery characteristics may limit this range.
Overall Dimensions
ULX1: 96.5 mm H x 67 mm W x 26.7 mm D (3.86 x 2.68 x 1.10 in.)
ULX2/SM58: 228.6 L x 51 mm Dia. (9 x 2 in)
ULX2/BETA 58: 220.9 mm L x 51 mm Dia. (8.7 x 2 in.)
ULX2/SM86: 213 mm L x 49 mm Dia. (8.4 in x 1.9 in)
ULX2/87, ULX2/BETA 87: 223.5 mm L x 51 mm Dia. (8.8 x 2 in.)
ULX4S: 43 mm H x 214 mm W x 163 mm D (1.72 in. x 8.56 in. x 6.52 in.)
ULX4P: 43 mm H x 214 mm W x 172 mm D (1.72 in. x 8.56 in. x 6.88 in.)
Net Weight
ULX1: 79 g (2.8 oz.) without battery
ULX2/58, ULX2/BETA 58: 289 g (10.2 oz.) without battery
ULX2/SM86: 251 g (8.8 oz.) without battery
ULX2/87, ULX2/BETA 87: 258 g (9.1 oz.) without battery
ULXS4: 1049 g (2 lbs, 5 oz.)
ULXP4: 1105 g (2 lbs, 7 oz.)
ULXP4, ULXS4 Receiver Audio Output
Connector
|
Unbalanced (1/4 in.)
|
Balanced (XLR)
|
Actual Impedance
|
3 kilohm
|
Mic. Level: 1848 Ohms Line Level: 75 Ohms
|
Pin Assignments
|
Tip = Hot Ring/Sleeve = Ground
|
1 = Ground 2 = Hot 3 = Cold
|
Phantom Power Protection
|
Yes
|
Yes
|
ULXP4, ULXS4 Receiver Antenna Input
Connector Type
|
BNC
|
Actual Impedance
|
50 Ohms
|
Nominal Input Level
|
-95 to -30 dBm
|
Maximum Input Level
|
+6 dBm (-20 dBm recommended)
|
Pin Assignments
|
Shell = Ground, Center = Signal
|
Voltage for Remote Power
|
12 Vdc, 150 mA maximum |