제품소개
"DSP" 사운드웹 시스템의 메인 컴포넌트로서 8개의 입출력을 가지고 있으며, 아날로그 입출력인 경우
24bit/96kHz의 A/D, D/A 컨버젼을 기본으로 하고, 옵션으로 AES/EBU 디지털 입출력을 지원하고 있습니다.
내부에 장착된 DSP는 게인 컨트롤러, 컴프레서나 게이트 등의 다이나믹 프로세서, 딜레이, 크로스오버, EQ, 매트
릭스, 믹서 등 모든 종류의 오디오 신호처리 프로세서들을 가지고 있어서 9088ii DSP 하나 만으로도 여러 가지 용
도의 오디오 시스템 구성할 수 있습니다.
두 개의 네트워크 포트를 통해 다른 9088ii나 9000ii와의 연결이 가능하고, CAT5 케이블을 사용하여 컨트롤 신호
와 8채널의 디지털 오디오 신호를 동시에 전달하도록 설계되었습니다.
Description
The 9088iis Networked Signal Processor forms the heart of the Soundweb system. In a single rack
space unit, it offers 8 analogue audio inputs, 8 analogue audio outputs, 200 MIPS of digital signal
processing, a pair of network jacks, and a variety of control options.
The front panel of the 9088iis has a number of LEDs to allow a quick view of activity on the audio inputs
and on the network. It also has a mini-DIN connector for an RS-232 serial port: this is normally used to
connect a PC for system setup and control.
The rear panel contains the audio inputs and outputs and the network jacks. It also contains a second
RS-232 port, which is normally used for control from an external controller such as AMX or Crestron.
Finally, it contains a control connector: see section 4 Control options for a description of how this is
used. Both control i/o and analogue i/o connections are made via "Phoenix" style two-part screw
terminals; the female connectors are shipped with the Soundweb unit, so installation can be made with
no soldering and no extra connectors to buy.
The 9088iis contains two preamplifier cards for the analogue inputs: each card handles four of, the
inputs. Three types of card are available: the analogue line card, the analogue mic/line card and an
AES/EBU Digital Input/Output card.
The line card gives a choice of two gain settings: 0 dB and 12 dB (intended as a pro/consumer switch).
The mic/line card provides a range of gain settings from 0 dB to 72 dB, together with phantom power
and phase reverse. In all cases, each input can be switched individually.
The Digital input card holds two AES/EBU stereo inputs and outputs, with input sample rates from 32kHz
to 96Khz. Output sample rates are user-selectable from 44.1kHz, 48kHz, 88.2kHz and 96kHz, and an
external word-clock sync input is provided for house-reference.
The 9088iis device can be configured with digital and analogue mic or line input cards to specification.
The analogue outputs are equipped with analogue attenuation after the DAC
stage. If the unit is used at anything lower than its full output level, it makes sense to apply the final gain
reduction in the analogue domain: in this way, the DAC noise is also attenuated and the signal to noise
ratio is kept at a maximum.
The core of the 9088iis contains two Motorola 56303 DSP chips, running at 100MHz each and thus
providing a total of 200 MIPS of DSP. There is also a block of dynamic RAM allowing a total of 11
seconds of audio delay. The main control processor is a Motorola 68000-series CPU, which runs a
real-time multi-tasking operating system; this CPU takes care of system operation and interfacing and
performs all the necessary housekeeping functions. Finally, the core contains a flash EPROM (see
section 5 Flash EPROM storage), in which is stored all of the software to run the unit, and also the unit's
configuration.
Technical Specifications
|
8 Analogue, electronically balanced, on Phoenix/Combicon removable screw connectors.
|
|
|
|
Nominal gain 0dB, electronically switchable to +12dB gain, input impedance 10kOhm
|
|
|
|
Nominal gain 0dB, electronically switchable up to +72dB, in +6dB steps, input impedance 3.5kOhm
|
|
|
|
+20dBu with 0dB input gain (+8dBu with 12dB gain)
|
|
|
|
|
|
|
Equivalent Input Noise (EIN)
|
<-128dBu typ with 150 Ohms source
|
|
|
|
48V nominal, selectable per input
|
|
|
|
2 x 2-channel inputs per card, sample rates accepted from 32 to 96kHz, auto selected, on Phoenix/ Combicon removable screw connectors
|
|
|
|
8 Analogue, electronically balanced, on Phoenix/ Combicon removable screw connectors.
|
|
|
|
|
|
|
AES/EBU Digital Inputs and Outputs
|
2 x 2-channel outputs per card
|
|
|
|
sample rates 44.1, 48, 88.2, 96kHz, user selectable, on Phoenix/Combicon removable screw connectors
|
|
|
|
|
|
|
|
|
|
|
|
<0.01% (20Hz to 20KHz, +10dBu output)
|
|
|
|
105dB typ. (22Hz to 22KHz unweighted)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Control ports (8 inputs and 8 outputs)
|
|
|
|
|
|
|
|
|
4.7kOhms to +5V (2-wire mode)
|
|
|
|
|
|
|
|
|
|
|
|
|
Opto output series impedance
|
|
|
|
|
Phoenix/Combicon connector for failsafe control.
|
|
|
|
|
|
|
Opto output withstanding voltage
|
|
|
|
|
2xRJ45 connectors for Soundweb network connection.
|
|
|
Maximum network cable length
|
300m/1000ft, longer distance using 9014 fibre converters
|
|
|
|
Signal Present (per input), CLIP (per input), network (front panel) input active, network output active, network Master indicator.
|